The Ocelot provides control of your X10 automation receivers with this home control interface that does it all - fully programmable to include macros, timers, IR transmission etc.
The Leopard 2 provides touch-screen control of your X10 automation receivers with an elegant, easy-to-use home control system that does it all - fully programmable to include macros, timers etc.
The Adicon RLY8-XA is connected to the Ocelot or Leopard via an RS485 wire. The unit then becomes a unique "module" on the ADICON network. High current relay outputs up to 270V AC at 5A.
The Adicon SECU-16 adds 8 low-current relays (0.5A) and 8 supervised input channels to an Ocelot or Leopard Control System. The 8 input channels may also be used as 8-bit A/DCs.
The Adicon SECU-16 adds16 supervised input channels to an Ocelot or Leopard Control System. The 16 input channels may also be used as 8-bit A/DCs and can detect shorted wires such as motion, rain, wind speed & temperature sensors.
The Adicon SECU16IR adds 16 zoned infrared outputs to control multiple IR devices such as TVs, DVD players and set-top boxes. It can be connected to the Ocelot and Leopard via the ADNET port to send an automated IR output to any zone desired.
The SpeakEasy Speech module interfaces to the Leopard or Ocelot controllers to play pre-recorded audio messages. Messages may be recorded using the on-board microphone or any audio line-level device such as a PC soundcard & MP3 player.
The Adicon Light sensor Bobcat is a single point module providing light level readings. It communicates with the Leopard or Ocelot Units. The light sensor bobcat can be used in an 8-bit (0-255) analog or digital (0-1) data mode.
The Adicon Temperature Bobcat is a single point module providing temperature readings from -29ºC to 77ºC. This unit communicates via RS485 to the Ocelot or Leopard products.
The Humidity Bobcat is a single point module providing humidity readings from 5% to 95% RH (Relative Humidity). This unit communicates via RS485 to the Ocelot or Leopard products.
The Adicon Contact Sensor Bobcat is a single point module for detecting contact closures such as relays or switches. The module is connected via RS485 to the Ocelot or Leopard unit.
RS485 Serial Bobcat provides an interface from the ADICON system (Leopard2 or Ocelot controller) to RS485 serial-controlled devices. The data transfer is output only from the Bobcat; it will not receive data.
The RS232 Serial Bobcat provides an interface from the ADICON system (Leopard2 or Ocelot controller) to RS232 serial-controlled devices. The data transfer is output only from the Bobcat; it will not receive data.
The RI304 is an A10 receiver which controls by standard or extended code, four Form A, 20 amp relays individually. Each relay has a manual ON/OFF switch and screw terminals for field connections. The latching relay holds last state upon power loss.
WHOME, the trusted supplier of automation products in Australasia for over 10 years.
Supplier of complete range of X10 & A10 home automation.
