The SAX15 is a potential free actuator/interface in a surface-mounted housing. The SAX15 can be used to switch appliances of other manufacturers using an input contact (max. 5A, 30 V A.C./D.C.), i.e. doorbell, electronic lock or heating system.
The SVX10 is an advanced X10 single phase signal repeater that boosts the strength of any X10 or A10 signal it receives.The SVX10 can be mounted within a junction box or connected in parallel behind a light switch or powerpoint.
The SAIX12 is a switch actuator equipped with two 230V inputs suitable for resistive, capacitive and inductive loads up to 16A. Allows remote and/or on-site operation of lighting and equipment.
The DAIX12 is a dimming actuator equipped with one 230V input suitable for incadescent lamps & halogen lighting at 230V and low voltage halogen lighting at loads between 25 - 250W. The DAIX12 replaces DAIX10 and DAX10.
The ZAX12 is a sun blind actuator with interface equipped with 230 V inputs. The ZAX12 can be used for easy automation of electrically operated sun blinds, roll-down shutters, curtains and screens based on 230 V motors.
The IMX10 is a multi-function interface micromodule equipped with four potential free inputs. This module must be installed in junction boxes and can be connected to switches or retractive switches.
The PIOX15 is an On/Off interface in modular housing for linking A10 devices to external care systems, i.e. social alarms and conventional (12V) alarm systems. The PIOX15 features two inputs and two outputs (potential-free and galvanically separated).
The SAX35 is a potential free actuator/interface in a surface-mounted housing. The SAX35 can be used to switch appliances of other manufacturers using an input contact (max. 5A, 30 V A.C./D.C.), i.e. doorbell, electronic lock or heating system.
The PMIX35 is a programming unit can be used to measure the strength of the signal and noise levels. This makes it possible to examine the lighting circuit, isolate any disturbances with a filter and test installed modules immediately.
The RFIX35 is a receiver that converts RF (Radio frequency) signals into A10 commands and sends them over the lighting circuit. Up to 256 addresses can be controlled and 8 remote controls can be assigned to one RF interface.
The IRIX35 is a receiver that converts IR (Infrared) signals into A10 commands and sends them over the lighting circuit. Up to 16 addresses can be controlled with one IR interface. NEC IR protocol compatible.
WHOME, the trusted supplier of automation products in Australasia for over 10 years.
Supplier of complete range of X10 & A10 home automation.
