Just plug an appliance module into any standard 240V outlet, then plug the appliance you want to control into the module. Set the appliance modules X10 address with the two dials on the front of the module and you're done...It’s that easy!
• Turn your appliances on and off no matter where you are in the house.
• Controls any 240V appliance up to 10A resistive load, 1A inductive load.
The appliance module works as a remote controlled switch or relay. the connected load can be used at any wall sockets in the house. As the X10 switch is simply inserted into wall sockets like an ordinary plug, there is no installation to be carried out. Just set the wheels on the front to the desired device address (eg. G7) and note this address down.
The load connected to the switch module can still be controlled locally by its own switch, but dont forget to leave the local switch in the "ON" position, as otherwise the load cannot be controlled by an X10 controller. Switch the load off by remote control. The unit responds to "standard" X10 commands. ie. All-Units-Off, On and Off.
Dimensions
Dimensions: Length 122, Width 52, Height 44 mm
