To order any of our products, you may purchase using our safe and secure online facilities or please call our Sales Hotline on

Phone: (02) 9764 6577

HOME AUTOMATION > X10 LIGHTING CONTROL

	2 Address Transmitter (sep. up/down) (micro) DIX2 (AU$99.00)
	QTY:
	The DIX2 is an A-10 micro module Transmitter that is wired behind momentary ('bell' press) switches (4 max). The switches connected to the DIX2 effectively become A-10 Transmitters, enabling them to control your X-10/A-10 Receivers and Interfaces. The DIX2 is similar to the DIX1 except that it controls only two X-10 addresses. However, the DIX2 has two connections per address, enabling one momentary switch to be used for on/bright commands and another to be used for off/dim commands. The DIX2 works best with 2-way momentary rocker switches as a momentary press up is used for on/bright and a momentary press down on the same switch sends off/dim commands. Note, the DIX2 does not directly control a load - it is an A-10 Transmitter only. Sends ON/OFF and DIM commands Can control up to a maximum of two addresses Two inputs per address; one for on/bright and another for off/dim Can only be applied with momentary switches Supports status request to ensure command reception Operation The wires of the DIX2 module can be connected to momentary ('bell' press) switches. With one module, a maximum of two addresses can be controlled by connecting it to either one 2-way momentary switch, or two 1-way momentary switches. Installation instructions Active and neutral wires are required to be connected to the DIX2 The DAIX10's address and optional features can be programmed by any X10 transmitter or interface. They can also be programmed by the special AT004 programmer/test receiver. A10 application and installation manual WHOME manual
	Back