| |
CLEARANCE
| |
4-Address Transmitter (micro module) DIX1 (AU$99.00) |
|
| |
|
|
| |
|
|
| |
Transmits ON/OFF and DIM/BRIGHT commands
Can control up to 4 X-10 addresses
Is used with momentary ('bell' press) switches in order to enable dim/bright
Supports status request to ensure command reception
The DIX1 is an A10 micro module Transmitter that is wired to momentary ('bell' press) switches (4 max). Each switch connected to the DIX1 effectively becomes an A10 Transmitter, enabling it to control your X10/A10 Receivers and Interfaces. The DIX1 is best used to initiate macros/scenarios or to control X10 receivers that are installed a distance away from the DIX1. The momentary switch enables the DIX1 to transmit dim and bright commands - a sustained press will send dim or bright commands, a quick press will send on or off commands. Note, the DIX1 does not directly control a load, it is an A10 Transmitter only.
Operation
The wires of the DIX1 module are connected to momentary switches, up to a maximum of four. Each switch controls an X-10 address. A quick press of the momentary switch will transmit an X-10 on or off command (toggle) - a sustained press will send dim/bright commands until the switch is released.
Installation instructions
- Active and neutral wires are required to be connected to the DIX1
Manual
Whome Manual
|
|
| |
|
|
| |
Back |
|
WHOME the trusted supplier of home automation for over 10 years in Australia and Asia.
Supplier of complete range X-10, A10 hom automation range of products
WHOME is the exclusive supplier of MARMITEK home automation. X-10 audio video, wireless and wired products in Australasia.
WHOME is the exclusive supplier of XANURA A10 home automation in Australasia
WHOME is the exclusive retailer of CM Technology products in Australasia
Purchase the entire range of Home automation products plus HAL, WGL and much more from WHOME.
|
|