The AD10 DIN switch is a receiver module designed to switch hard–wired circuits.
Receiving X10 commands sent from X10 transmitters, the AD10 enables automation control of your fixed on/off loads. It can also be switched manually by wiring a continuous or momentary switch to the input terminals. When using momentary switches it is possible to wire many switches in parallel for easy wiring of 2-way switching (or more).
A manual override switch can be set to either force off the AD10, force on permanently or when in the 'auto' position the AD10 will respond to X10 signals and commands from the input switches.
The AD10 DIN switch is a receiver module designed to switch hard–wired circuits.
A manual override switch can be set to either force off the AD10, force on permanently or when in the 'auto' position the AD10 will respond to X10 signals and commands from the input switches.
The AD10 may be wired inside a DIN rail enclosure in the switchboard, or can be installed in a suitable enclosure located in the roof space above the load to be controlled.
Controls up to 16A resistive loads, 3A motors and 2000W lamps
